Ultimate-speed ULSP 2 A1 Bedienungsanleitung PDF herunterladen (Seite 8)

ULSP 2 A1

Initial operation

Inserting/replacing the battery

♦ Remove the protective cap and undo the four screws

on the rear of the device.

♦ Remove the rear part of the housing.

♦ Insert a battery of type CR2032 in the battery holder.

Ensur

e that the polarity is correct: the battery’s positive

terminal should face upwards.

♦ Replace the rear of the housing again using the screws

ou previously removed.

NOTE

► When all three LEDs start ﬂ ashing, the battery needs to

be r

eplaced.

Switching the device on and oﬀ

♦ Remove the protective cap and press the TEST button

for around 3 seconds. The LEDs

ﬂ ash brieﬂ y in

succession (RED >> YELLOW >> GREEN). When only the

red LED is ﬂ ashing, the device is in standby mode.

♦ If no measurement takes place within 20 seconds, the

vice switches itself oﬀ automatically. The LEDs

simultaneously ﬂ ash three times.

♦ Alternatively, you can press the TEST button

for

around 3 seconds to switch the device oﬀ manually.

IB_91055_ULSP2A1_SK_RO_OS.indb 5IB_91055_ULSP2A1_SK_RO_OS.indb 5 22.07.13 11:5322.07.13 11:53

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Keine Kommentare

Ultimate-speed ULSP 2 A1 Bedienungsanleitung Seite 8