Ultimate-speed Z31365 Bedienungsanleitung PDF herunterladen (Seite 7)

7 GB

rubber hammer can help with this). Fasten with

the spring washers

and screws

supplied

(see Fig. A).

2) Insert the down rod section (without plug)

into the linking piece

(see Fig. B). Take the

plate

and pull the pin

which is

underneath the plate

in an outwards

direction (see Fig. C). Place the plate

, as

seen in ﬁg. D, onto the down rod section

(without plug)

and let it glide through the

rod to the lowest hole on the rod

. Push the

through the existing hole and allow the

plate

to slide down (see Fig. D). The

position of the plate is now secured.

3) Load the rim with tire (see Fig. E). Proceed in

same sequence for the next tire (see Fig. F).

4) Now, put in place the end rod section (with

plug)

(see Fig. G). Proceed as described

above, until all 4 tires are properly stored (see

Fig. H).

5) If you would like to make use the storage

container

for storing assembly items,

carefully remove the stopper from the end rod

section

(e.g. with the aid of a screwdriver).

Place the storage container

on the end rod

section

Notes: the two individual parts of the storage

container

must be joined with the

corresponding screws

before being used.

For this, please use a crosshead screwdriver,

size PH1.

Instructions for use

of accessories

The tyre chips

are placed on the valves as a

simple means of labelling when storing tyres.

The air pressure gauge

is used for taking rough

measurements. If needed, go to the nearest petrol

station to check the pressure more accurately.

Use: push in the measuring rod of the air pressure

gauge

fully before use. Then place on valve

and read oﬀ pressure in desired units on the

measuring rod. If the pressure is too high, the valve

can be pressed in using the button on the side of

the gauge to let out air. The tread gauge

used for taking rough measurements. Go to a

garage if necessary. The required proﬁle

measurements may vary by country. Therefore

please ﬁnd out about the speciﬁc regulations in

your country.

The storage container

is for the storage of

assembly accessories.

Maintenance and care

The tyre stand and the central linking piece

should be checked regularly for damage or

wear.

Use a damp cloth for cleaning. Do not use any

cleaning ﬂuids, solvents or sharp objects.

Disposal

The packaging is made entirely of

recyclable materials, which you may

dispose of at local recycling facilities.

Contact your local refuse disposal authority for

more details of how to dispose of your worn-out

product.

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

Ultimate-speed Z31365 Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Ultimate-speed Z31365